Oil in water, Water Cut Analysers

Oil in water analysers

  • The range of products are designed to be the most robust, accurate and cost-effective (CAPEX & OPEX) oil in water analysers available on the market.
  • An oil in water Analyser that provides unmatched reliability and accuracy to a wide range of applications such as produced water monitoring in the upstream Oil and Gas Industry, and effluent monitoring in the Manufacturing & Chemical Processing industry.  
  • For general purpose applications such as Oil Leak Detection in Cooling Water, Environmental, Municipal Wastewater, PAH Monitoring, Marine Bilge Monitoring, Municipal Drinking Water & Offshore Wind Power Substation Discharge Monitoring.
  • The Rapid Wave Ultrasonic Cleaning and Laser Induced Fluorescence, combined with the small footprint and robust design make it an ideal solution for applications where long periods between service/maintenance intervals are a necessity. The inline probe deployment makes it ideal for in-situ measurements where a sample system is not desired.
  • 316SS Exd Hazardous ATEX, IECEx and C1D1 Certification

Water Cut analysers (BS&W)

Water cut Analyser IS ALL ABOUT WATER IN OIL.

Water Cut Monitors (also known as BS&W, OWD, WFM or Water in Oil Analysers) for Oil & Gas Industry as well as Water In Oil Monitors for lubrication systems in Heavy Machinery and Marine applications.

Water Cut Meter is designed around reliable capacitance technology. We have added decades of knowledge and experience to overcome problems normally associated with capacitance probes. The ZT-100’s built in logic will compensate for the vast temperature effects in the dielectric constant of the water while recognizing the much smaller effects on the dielectric constant of the oil. The ZT-100 is a loop powered Intrinsic Safe device with HART Interface. All setup can be done from a remote location using a dedicated PC interface.

The Water cut Meters can be installed inline, in bypass or as insertion. Built to any piping spec in the materials of your choice. 1 inch or 48 inch, we cater for all sizes.

The Water cut Monitor determines the percent water cut in an oil emulsion without requiring the physical separation of the fluids. The emulsion stream is continuously monitored for capacitance and converted into percentage of water by the Water cut Monitor logic.

The Water cut meter measures water in oil primarily in crude oil and is used in applications like fiscal metering, desalting, export metering, process control, on test separators, on- and offloading, etc.